Page 18 Modeling a Tank: Body Detail

Turn on the 'hydraulic curves' layer and turn off the 'mech detail curves' layer.

Select the curve shown and revolve it by snapping to the end of the curve and dragging horizontally with the shift key down to keep the axis Ortho as shown below.

From the top view select the curves shown below and Revolve them. 'End' osnap to the left end of the curves and use a vertical axis relative to the view.

Select the curve highlighted below and from the front view and Extrude 'Cap=Yes' it a distance of 110.

Note: Some of these objects will be needed to be dragged and rotated when the fender file is merged.